Daymak Boomerbuggy Covered User Manual download pdf (Page 10)

Operating Instructions

Getting Started

Before the  rst use, you must charge your scooter completely. This should take approxi-

mately 8 to 12 hours.

Getting On/Off

Before getting on or o your scooter, always make sure that the keys are not in the ignition

and that the scooter is o . This is a safety measure to prevent any unwanted injury due to

accidental engaging of levers. Make sure the door is completely closed before moving.

Parking and Locking your E-scooter

When you want to park your e-scooter for a short time, either when you have reached your

destination or are at home, follow these steps:

1. Stop the e-scooter and position it as you want it.

2. Get o the e-scooter, making sure to keep it balanced.

3. Close the door, and use the key to lock it.

Forward and Reverse

First, make sure you are seated comfortably. Put the key into the ignition and turn the

scooter on. You will know that the scooter is active when the LEDs light up on the control

panel. Set your scooter to the lowest speed possible. You may adjust the speed once you

are comfortable with operating the scooter.

Start by gently squeezing the right lever. Gradually apply more pressure to the lever and

the scooter will begin to pick up speed. If you have set your speed to the lowest, your top

speed will be restricted.

Once you are in motion, gently release the lever and the scooter will smoothly come to a

stop. Repeat moving forward and braking a few times to get used to the motion.

Next is to practice reversing. To reverse, gradually squeeze the left lever. Same as before,

the more pressure applied to the lever, the faster the scooter will move. Practice reversing

and stopping a few times to used to the motion.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Daymak Boomerbuggy Covered User Manual Page 10